NOTE - THE NOTED DISAPPROVED ITEMS MAY NOT CONSTITUTE A COMPLETE LIST OF VIOLATIONS. THE DESIGNER IS TO CONDUCT A COMPLETE RE-REVIEW OF THE PLANS FOR ADDITIONAL VIOLATIONS OF THE STANDARD COMMENTS AND INCORRECT INFORMATION PRIOR TO RESUBMITTING.
System plans must be picked up within 30 days. All system plans left longer than 30 days will be discarded as abandoned.
RED LEG BREWING - SUITE B
04630 FORGE RD
||FYI||RESUBMITTED: The plans have been re-submitted, and the disapproved issues have been addressed as follows: APPROVED.
**PLEASE NOTE** ALL COMMENTS FOUND ON PREVIOUS PLAN REVIEWS REMAIN ENFORCEABLE UNLESS OTHERWISE NOTED IN THIS REVIEW.
1) Revised splice sheets for CO2 storage resubmitted 9/26/13: New storage room/closet 109A was constructed for the CO2 storage.
Red Leg will have 50 lbs on line only but has constructed this room to accommodate future increase. OK
A2.1, M-1 A0-3
Ventilation exhausted duct of through room and CO2 detector wired to alarm light and horn. Fan to have continuous operation.
CO2 detector is AIR TEST TECHNOLOGIES MODEL TR 7200 audio & visual alarm.
2) Please ensure that PPRBD mechanical and construction depts review the revised splice dated 9/24/13
At this time PPRBD has not reviewed or released this splice set.
||FYI||Red Leg Brewing, 4630 Forge Rd, Suite B: interior remodel - change of occupancy from S1/B to F2/B
SYSTEMS: none required
CN:Code: 09 IEBC -09 IFC - 11 PPRBC /Class: F2, B / Const: III-B /Stories: 1 + MEZZ /Size: 4158 /OL: 64
Additional Comments: ONE 100 LB CO2; small quantities of cleaners-irritants and corrosives
BELOW MAQs and Permit amounts|
|FYI||CHEMICAL INVENTORY AS DECLARED- SEE ELECTRONIC DOCUMENTS/EMAILS
The storage, use and handling of hazardous materials in quantities not exceeding the maximum allowable quantity per control area indicated in Tables 2703.1.1(1) through 2703.1.1(4) shall be in accordance with the IFC 2009, as amended Sections 2701 and 2703.
Chemical Inventory Indoors: is below the Annual Operational Hazardous Materials permit threshold for Inert-Asphyxiant gas, irritant & OHH materials, and corrosives.
The chemical inventory as declared SEE ELECTRONIC DOCUMENTS does NOT exceed the MAQs. The chemical inventory as declared does not exceed the CSFD Annual Operational Hazardous Materials Permit amounts. NO annual permit is required. No annual permit inspection is required.
|Attention||ONE 100 lb CARBON DIOXIDE VESSELS (CO2)
NFPA = 1-0-0 special = SA
TLV-TWAs, 5000 ppm (ACGIH, 2004)
TLV-TWA 15 MIN STEL 30,000 ppm
High Pressure liquid and gas. Can cause rapid suffocation....CO2 IS AN ASPHYXIANT
May cause frostbite.
****** ATTENTION *******
Indoor storage of compressed gases falling into categories such as asphyxiants, irritants can be hazardous regardless of the type of gas involved simply due to the hazards related to asphyxiation.
RECOMMENDATION NOTE: Storage areas where an accumulation of inert gas could occur should be continuously monitored with an appropriate alarm system to indicate an oxygen deficient atmosphere. Recommended
**** No CO2 detector or audible/visual alarm is noted on plan sheet. |
|Disapproved||VENTILATION 2704.3 CONTINUED
6. The location of both the exhaust and inlet air openings shall be designed to provide air movement across all
portions of the floor or room to prevent the accumulation of vapors.
7. Exhaust ventilation shall not be recirculated within the room or building if the materials stored are capable of
emitting hazardous vapors.
*** Review and release for permit by PPRBD Mechanical Dept. is required for the ventilation system at the CO2 storage location.
****** At this time, PPRBD Mechanical has released for permit these plans. However, it is not known whether CO2 and requirement for ventilation was reviewed by Mechanical Dept. Please request that Mechanical Dept. review and reply to this comment.
Facilities shall declare the storage and use of small Insulated Carbon Dioxide Systems used in Beverage Dispensing.
Gaseous Carbon Dioxide is an asphyxiant gas and exposure to high concentrations may cause toxic effects including asphyxiation. To provide for the safety of building occupants and emergency personnel, ventilation in accordance with the IFC Sections 3007.2, 2704.3 or 2705.1.9 is required where concentrations of this gas are stored or present.
CO2 systems of 100 lbs to 1000 lbs shall comply with the requirements in these comments. SEE ADMINISTRATIVE RULING ATTACHED TO COMMENTS. Please contact Kay Yeager, CSFD if you have further questions @ 719 385-7356
All new or proposed building ventilation system designs shall submit for review and permit approval to the Pikes Peak Regional Building Department.
*** ATTENTION**** 2704.3 VENTILATION
Indoor storage areas and storage buildings shall be provided with mechanical exhaust ventilation or natural
ventilation where natural ventilation can be shown to be acceptable for the materials as stored.
System requirements. Exhaust ventilation systems shall comply with all of the following:
1. Installation shall be in accordance with the International Mechanical Code. (section 502.8.1 - 502.8.1.1)
2. Mechanical ventilation shall be at a rate of not less than 1 cubic foot per minute per square foot of floor area over the storage area.
3. Systems shall operate continuously unless alternative designs are approved.
4. A manual shutoff control shall be provided outside of the room in a position adjacent to the access door to the room or in an approved location. The switch shall be of the break-glass type and shall be labeled:
VENTILATION SYSTEM EMERGENCY SHUTOFF.
5. Exhaust ventilation shall be designed to consider the density of the potential fumes or vapors released. For
fumes or vapors that are heavier than air, exhaust shall be taken from a point within 12 inches of the floor.|
***This facility is required to have a Construction Hazmat Inspection.
*** To Schedule the hazardous materials construction inspection please contact the Division of the Fire Marshal @ 719-385-5978. *** For further questions or information please contact the Division of the Fire Marshal main number at 719-385-5978.
Material Safety Data Sheets (MSDS) for all hazardous materials shall be either readily available on the premises as a paper copy, or where approved, shall be permitted to be readily retrievable by electronic access. Approved electronic access shall be as follows:
1. Media shall be USB Flash Drive.
2. Format shall be Microsoft Word 2000 or newer docu-ment, PDF, or other approved format.
Where a Knox Box is located at a facility, one USB de-vice shall be stored in the Knox Box and one device shall be located in an approved location(s). All devices and content shall be maintained.
|FYI||Unless otherwise exempted by the fire code official, visible hazard identification signs as specified in NFPA 704 for the specific material contained shall be placed on stationary containers and above-ground tanks and at entrances to locations where hazardous materials are stored, dispensed, used or handled in quantities requiring a permit and at specific entrances and locations designated by the fire code official.
Individual containers, cartons or packages shall be conspicuously marked or labeled in an approved manner. Rooms or cabinets containing compressed gases shall be conspicuously labeled: COMPRESSED GAS.
Signs and markings required by Sections 2703.5 and 2703.5.1 shall not be obscured or removed, shall be in English as a primary language or in symbols allowed by this code, shall be durable, and the size, color and lettering shall be approved.
Sources of ignition shall comply with Sections 2703.7.1 through 2703.7.3.
Smoking shall be prohibited and "No Smoking" signs provided as follows:
1. In rooms or areas where hazardous materials are stored or dispensed or used in open systems in amounts requiring a permit in accordance with Section 2701.5.
2. Within 25 feet (7620 mm) of outdoor storage, dispensing or open use areas.
3. Facilities or areas within facilities that have been designated as totally "no smoking" shall have "No Smoking" signs placed at all entrances to the facility or area. Designated areas within such facilities where smoking is permitted either permanently or temporarily, shall be identified with signs designating that smoking is permitted in these areas only.
4. In rooms or areas where flammable or combustible hazardous materials are stored, dispensed or used.
Signs required by this section shall be in English as a primary language or in symbols allowed by this code and shall comply with Section 310.
|FYI||Labeling - An NFPA 704 compliant Hazard Placard is required for each pedestrian entry door rooms containing hazardous materials in excess of the exempt amounts (this door could be interior or exterior) and all such doors shall be included. The minimum size of the Hazard Placard shall be 15" by 15". This requirement is subject to verification at the time of the Hazardous materials Inspection prior to signing the Fire Final.|
|FYI||Compressed gas containers, cylinders, tanks andsystems shall be secured against accidental dislodgement and against access by unauthorized personnel.
Compressed gas containers, cylinders and tanks shall be separated from incompatible materials
Compressed gas containers, cylinders, tanks and systems shall not be placed in areas where they are capable of being damaged by falling objects.
Areas used for the storage, use and handling of compressed gas containers, cylinders, tanks and systems shall be secured against unauthorized entry and safeguarded in an approved manner.
Compressed gas containers, cylinders and tanks shall be secured to prevent falling caused by contact, vibration or seismic activity. Securing of compressed gas containers, cylinders and tanks shall be by one of the following methods:
1. Securing containers, cylinders and tanks to a fixed object with one or more restraints.
2. Securing containers, cylinders and tanks on a cart or other mobile device designed for the movement of
compressed gas containers, cylinders or tanks.
3. Nesting of compressed gas containers, cylinders and tanks at container filling or servicing facilities or in seller#s warehouses not accessible to the public. Nesting shall be allowed provided the nested containers, cylinders or tanks, if dislodged, do not obstruct the required means of egress.
4. Securing of compressed gas containers, cylinders and tanks to or within a rack, framework, cabinet or similar assembly designed for such use. Exception: Compressed gas containers, cylinders and tanks in the process of examination, filling, transport or servicing.
Compressed gas containers, cylinders and tanks designed for protective caps, collars or other protective devices shall have the caps or devices in place except when the containers, cylinders or tanks are in use or are being serviced or filled.|
|FYI||LABELING AND MARKING
** Stationary compressed gas containers, cylinders and tanks shall be marked with the name of the gas Markings shall be visible from any direction of approach.
** Portable compressed gas containers, cylinders and tanks shall be marked in accordance with CGA C-7.
Piping systems shall be marked in accordance with ANSI A13.1.
** Markings used for piping systems shall consist of the content#s name and include a direction-of-flow arrow.
** Markings shall be provided at each valve; at wall, floor or ceiling penetrations; at each change of
direction; and at a minimum of every 20 feet or fraction thereof throughout the piping run.
Portable containers, cylinders and tanks. Portable compressed gas containers, cylinders and tanks shall be
marked in accordance with CGA C-7.
Signs clearly establishing the location and identity of shut-off valves are to be provided.
All inert piping systems shall be identified by appropriate labeling with the name of the gas.
Warning signs shall be posed at each entrance to the room or enclosure where the bulk inert gas system is installed. Wording shall include:
WARNING ---(name of gas)
HIGH CONCENTRATION OF GAS MAY OCCUR
IN THIS AREA AND MAY CAUSE ASPHYXIATION.
VERIFY THAT OXYGEN CONCENTRATION IS ABOVE 19.5% BEFORE ENTERING
AND DURING ACTIVITY IN THIS AREA.|